Windows command line tutorial [part3]



The Firewall
netsh” is for configuring windows firewall.
We can configure the firewall from command line(cmd.exe) easily. I am including some firewall command below.
Start firewall:
Netsh> help
netsh firewall ?
Show all current configuration of the firewall:
netsh firewall show config
Firewall “set” command:
(This will set up the firewall to allow a program.)
netsh firewall set (see helps)
Enable the firewall
netsh firewall set opmode enable
ICMP setting:
netsh firewall set icmpsetting 8
netsh firewall set icmpsetting type=all mode=enable
firewall service:
netsh firewall set service type=REMOTEADMIN mode=enable scope=CUSTOM address= ip.ip.ip.ip
netsh firewall set service REMOTEDESKTOP ENABLE
Adding new rules “The ‘add’ command”:
netsh firewall add ? (For helps)
netsh firewall add allowedprogram c:somewhereyourncnc.exe virus ENABLE
netsh firewall add allowedprogram program= c:somewheresomethingsrat.exe name=legit mode=enable
Open a port:
netsh firewall portopening TCP 1337 backdoor
netsh firewall portopening protocol=TCP port=31337 name=another mode=ENABLE scope=CUSTOM address=ip.ip.ip.ip profile=ALL interface=eth0
Delete a allowed program:
netsh firewall delete allowedprogram c:somewheresomethingvirusnc.exe
netsh firewall delete allowedprogram program=c:here1337deletethehackerbye.exe profile=ALL
Turn into default windows firewall:
netsh firewall reset